Silvercrest SSC 200 A1 User Manual download pdf (Page 50)

48

4.8 Material damage

Warning! Follow the instructions given

below to prevent material damage.

• Never operate the slow cooker without

water. This could cause it to overheat.

For the same reason, never operate the

slow cooker without the cooking pot 4 in

place .

•The lid 1 and the cooking pot 4 are

breakable. You should therefore treat

them with care.

•The lid 1 and the cooking pot 4 are

liable to crack if subjected to sudden

temperature changes. You should

therefore always let them both cool

down before immersing them in water.

•The lid 1 and the cooking pot 4 are not

suitable for searing or for use in the

oven, microwave, freezer or plate

warmer.

• Always place the appliance on a level,

dry, non-slip surface to stop it tipping

over or sliding off.

• Do not place the appliance on top of a

hot hotplate.

• The appliance and accessories may not

be put in a microwave oven.

• If you serve the finished dish in the hot

cooking pot 4, place a heat resistant

table mat underneath it to prevent

marking the table top.

5. Unpacking and setting up

Note: As the appliance is supplied with a

thin film of grease, there might be a small

amount of smoke and odour the first time

it is used. This is not harmful and will stop

after a short while. Please ensure adequate

ventilation during this process.

1. Remove the individual parts from the

packaging.

2. Check that the individual parts are all

present (see “1.2 Scope of supply” on

page 44) and are undamaged.

3. Clean the appliance thoroughly before

using it for the first time (see

“10. Cleaning” on page 53).

4. Place the appliance on a level, dry, non-

slip surface so that the appliance can

neither fall over nor slide off.

5. Stand the cooking pot 4 in the base 6.

6. Pour half a litre of water into the cooking

pot 4.

7. Place the lid 1 on the cooking pot 4.

8. Insert the plug into a suitable earthed

socket (see “3. Technical data” on

page 45).

9. Turn the control knob to the 8 setting

“HIGH”.

The indicator light will 7 come on and

the appliance will begin heating up.

10.Allow the appliance to operate switched

on for approximately 60 minutes.

11. Switch the appliance off by turning the

control knob 8 to “OFF”.

12.Disconnect the mains plug.

13.Let the appliance cool down and then

clean it again (see “10. Cleaning” on

page 53).

The appliance is now ready to use.

RP100155 slow cooker LB1 Seite 48 Donnerstag, 19. Juni 2014 11:57 11

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 56 57 58

Comments to this Manuals

No comments