Silvercrest SWW 1500 A1 User Manual download pdf (Page 13)

Assembly/Handling and operation

SWW 1500 A1

Remove the device from the wall again. With an electric drill and an 8 mm ♦

drill bit drill the hole to a depth of, at least, 40 mm, subsequently insert the

rawlplug into the hole.

Hang the device on the wall and tighten the screw with the angle bracket ♦

(see diagram Tightening the angle bracket).

Diagram Tightening the angle bracket

Insert the power plug into a mains wall socket. ♦

Handling and operation

NOTICE

All functions can be switched both with the buttons on the device and with ►

the remote control.

In this section you r

eceive important information for the handling and operation

of the device.

Switching the device on and oﬀ

With the main switch POWER

the device is completely disconnected from the

mains power.

Firstly switch the main switch POWER ♦

on and/or lastly oﬀ when you are

no longer operating the device.

Heating operation

Activate the main switch POWER ♦

to switch the device on. In the display

appears brieﬂ y and subsequently the current device temperature in the

area of the integrated temperature sensor. The device is now in standby

mode. In the display the symbol for the frost protection function blinks.

Press the button POWER/MODE ♦

and/or

. The device switches on

with the low heat output (LOW). In the display appears .

Press the button POWER/MODE ♦

and/or

again to set the high heat

output (HIGH). In the display appears .

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 127 128

No comments

Silvercrest SWW 1500 A1 User Manual Page 13