Silvercrest SWKS 2200 A1 User Manual download pdf (Page 38)

36

GB

5. How to use

DANGER! Risk of electric

shock!

• Only connect the device to an easily ac-

cessible wall socket whose voltage cor-

responds to the specifications on the

rating plate. The wall socket must contin-

ue to be easily accessible after the de-

vice is plugged in.

• Pull the mains plug6 out from the wall

socket after every use.

• Remove all packing material.

• Check to ensure that all parts are pre-

sent and undamaged.

• Place the device on a dry, level, non-slip

surface.

6. Before using for the

first time

1. Fill the kettle

2

up to the marking

MAX 1.7L

on the water level display

3

and heat the water (see “Using the kettle”

on page 36).

2. Pour the water out and rinse out the ket-

tle2 with fresh water.

3. Repeat this process. Then it is safe to

use the device.

7. Using the kettle

DANGER! Risk of injury

through scalding!

• It is always necessary to close the lid9

when heating water, as boiling water

may otherwise spray out!

• Do not open the lid9 while the water is

boiling.

• Fill the kettle

2

only to the maximum fill-

ing level (

MAX 1.7L

), as boiling water

may otherwise spray out.

• Do not bend over the kettle2 when you

open the lid9 and the contents are still

hot. There is a danger of being scalded

by escaping steam.

• The kettle2 becomes very hot during

operation. Only touch it at its handle7

and only use the release button8 and

the on/off switch5.

WARNING! Risk of material damage!

Never put alcohol, sugar or milk into the ket-

tle2!

Water as foodstuff

Water is a very sensitive foodstuff and can go

bad due to germs forming. Please take note:

• Always use fresh drinking water in the

kettle2.

• Pour water away, which has been

standing in the kettle2 for longer than

approx. 1 hour.

• Do not reboil cooled down water.

Boiling water

1. Remove the kettle2 from the device

base4.

2. Press the release button8 to open the

lid9.

3. Fill the desired amount of fresh drinking

water into the kettle2. Keep it upright

or place it on an even surface to be

able to read the water level display3

correctly.

4. Close the lid9, by pressing it down-

wards.

5. Place the kettle on the device base4.

6. Insert the mains plug6 into a wall sock-

et corresponding to the technical data.

7. Press the on/off switch5 down, until it

lights up blue and locks into place.

8. The device automatically switches off as

soon as the water starts to boil.

9. Disconnect the mains plug6 from the

wall socket.

10.Remove the kettle2 from the device

base4 and pour the water out.

__RP100469_B5.book Seite 36 Donnerstag, 13. Februar 2014 3:48 15

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 53 54

Comments to this Manuals

No comments