Silvercrest SFR 1200 A1 User Manual download pdf (Page 52)

50

GB

6.3 Shaving

DANGER! Risk of electric

shock!

The hand-held device and the plug-

in power unit are not waterproof

and are therefore not allowed to be

used in a shower/bath.

WARNING!

• Do not use the device on open wounds,

cuts, sunburn or blisters.

• Do not place excessive pressure on the

shaving foils1. They are thin and can

be damaged easily.

NOTES:

• The device is suitable for both dry and

wet shaving (Wet & Dry).

• Initial use may cause temporary irrita-

tion or redness of the skin, as the skin

has to adjust to shaving. This is normal

and usually lasts between 2 and

4weeks.

Dry shaving (Rechargeable bat-

tery and mains operation)

• Hold the device at a right angle to the

skin surface and gently guide it over

your face.

• Shave against the direction of your

beard growth.

• Stretch your skin in complicated areas,

such as the chin, to achieve better re-

sults.

• Switch off the device after shaving,

clean the parts carefully (chapter

"Cleaning and maintenance of the de-

vice" on page 51) and place the protec-

tive lid11 onto the shaving head4 to

protect the shaving foils1 and the long

hair trimmer12.

Wet shaving (only for battery

operation)

DANGER! Risk of electric

shock!

The hand-held device and the plug-

in power unit are not waterproof.

Wet shaving is only allowed when

using battery power.

WARNING! Risk of material dam-

age! For wet shaving use shaving foam or

lather only; never use shaving gel or shaving

cream. This could adhere to the cutter

blocks.

• Before shaving, smooth a thin layer of

shaving foam on your face.

• Shave your face as described in the

chapter "Dry shaving (Rechargeable

battery and mains operation)".

• If shaving foam should clog the shaving

head

4

, clean the shaving head under

running water (chapter "Cleaning and

maintenance of the device" on page 51).

Cutting long hair

Use the long hair trimmer12 on the back of

the shaver to shorten your beard and side-

burns.

1. Take off the protective lid11.

2. Push the long hair trimmer12 up.

3. Switch on the shaver with the on/off

switch6.

4. After use, switch the device off, slide

the long hair trimmer12 back to its

original position and clean the device

(chapter "Cleaning and maintenance

of the device" on page 51).

Designer stubble

NOTE: depending on beard growth and

shaving, the appearance of a designer stub-

ble can vary greatly.

__GRA90253_B5.book Seite 50 Dienstag, 23. April 2013 2:18 14

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 73 74

Comments to this Manuals

No comments