Silvercrest SKAS 1000 A16 Specifications download pdf (Page 53)

Section 2

Fault Code Diagnostics

145 91 Range shift disengagement error Complete the pneumatic requirements flowchart.

If no issues are found with the air system, contact

OnTrac at 866-668-7221 and request a ZF-FreedomLine

transmission specialist.

146 92 Range shift changeover error Complete the pneumatic requirements flowchart.

The range actuator did not correctly engage into the rail.

Using TransSoft, verify that the range position sensor

counts are outside of the nominal range: 80 to 130 or 490

to 590. The measured values should not drift or show

signal disturbances after range shifting. Values outside

range, exchange main transmission. If error occurs

sporadically: When submitting a warranty claim under

standard warranty conditions, the complete TCU should

be replaced and the entire unit submitted with warranty

claim. Out-of-warranty only and/or no warranty claim

submitted, replace the lower part of TCU.

For assistance contact OnTrac at 866-668-7221 and ask

for a transmission specialist.

147 93 Range shift engagement error Complete the pneumatic requirements flowchart.

The range actuator did not correctly engage into the rail.

Using TransSoft, verify that the range position sensor

counts are outside of the nominal range: 80 to 130 or

490 to 590. The measured values should not drift or

show signal disturbances after range shifting. Values

outside range, exchange main transmission. If error

occurs sporadically: When submitting a warranty claim

under standard warranty conditions, the complete TCU

should be replaced and the entire unit submitted with

warranty claim. Out-of-warranty only and/or no

warranty claim submitted, replace the lower part of

TCU.

For assistance contact OnTrac at 866-668-7221 and ask

for a transmission specialist.

148 94 Splitter selection fault; splitter cylinder

does not disengage

Complete the pneumatic requirements flowchart.

The splitter group does not leave the previous position

within defined time. Using TransSoft, verify that the

splitter position sensor counts are outside of the nominal

range: 70 to 140 or 500 to 620.

The measured values should not drift or show signal

disturbances after splitter shifting. Values outside range,

exchange main transmission. If error occurs

sporadically: When submitting a warranty claim under

standard warranty conditions, the complete TCU should

be replaced and the entire unit submitted with warranty

claim.

Out-of-warranty only and/or no warranty claim

submitted, replace the lower part of TCU.

For assistance, contact OnTrac at 866-668-7221 and ask

for a transmission specialist.

ISO Fault Code Diagnostics

NOTE: ISO display codes may not be available on vehicles built prior to January 2006.

ISO Fault

Identifier

ISO Display

Fault Codes

(J587 Display) Fault Description

Repair Instructions

NOTE: The following repair instructions pertain to

active faults only. For information and instructions

about inactive faults, please contact OnTrac at

866-668-7221 and request a transmission

specialist.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 191 192

Comments to this Manuals

No comments

Silvercrest SKAS 1000 A16 Specifications Page 53

Comments to this Manuals

Related products and manuals for Coffee makers Silvercrest SKAS 1000 A16