Silvercrest SNM 33 A1 Service Manual download pdf (Page 12)

7

Winding the bobbin

a. Spool pin felt

Place an empty bobbin on spindle.

Take the thread from the spool through the

guide to the bobbin.

Wind the thread a few times by hand around

the empty bobbin in a clockwise direction.

Push the bobbin to the right towards the

bobbin winding position.

Press the foot control gently. The bobbin

will stop winding when it is full. Push the

bobbin to the left to "sewing position" and

remove it.

When the bobbin winder

spindle is in "bobbin winding" position, the

machine will not sew-the hand wheel will

not turn. To start sewing, push the bobbin

winder spindle to the left (sewing position).

Please Note:

a

Inserting the bobbin

Attention:

Turn power switch to off ("O").

When inserting or removing the bobbin, the

needle must be fully raised.

- Open the hinged cover. (1)

- Hold the bobbin case with one hand.

Insert the bobbin (2) so that the thread

runs in a clockwise direction (arrow). (3)

- Put the thread under the tension spring.

(4)

- Hold the bobbin case by the hinged latch.

(5)

- Insert it into the shuttle. (6)

1

2

3

4

5

6

Silver Crest SNM 33 A1

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Comments to this Manuals

No comments