Silvercrest KH 2130 User Manual download pdf (Page 9)

- 7 -

Note:

Observe the colour coding:

The white CINCH plug carries the left >

audio channel signal and belongs in

the white CINCH socket.

The red CINCH plug carries the right >

audio channel signal and belongs in

the red CINCH socket.

The yellow CINCH plug carries the >

video signal and belongs in the yellow

CINCH socket.

If required you can connect a second •

device as well, with the transmitter and

for this select the socket "AV IN 2" u.

If the signal source of your signal is •

available via a SCART connection,

you can use the supplied SCART—

CINCH adapter "OUT" 2@ between

the device and the CINCH—3,5mm

jack cable 2).

The A/V output of your signal source •

is now occupied. If you, nevertheless,

want to connect the signal source to

a TV, connect the TV via the socket

"OUTPUT TO TV" y to the transmitter

q. For this you can use either one of

the supplied CINCH—3,5mm jack ca-

bles 2) or, if both are already

occupied, an equivalent cable from

your local dealer.

Infrared connection

You can control the signal source via the

remote control even if you are not in the

same room. The receiver d picks up the

signal and sends it back to the transmitter

q which then redirects the signal via the

infrared cable 2# to the signal source.

For this you connect the supplied infra-•

red cable 2# to the transmitter's infrared

connection socket t.

Remove the protective foil from one •

of the supplied adhesive pads and at-

tach the pad to the rounded off side of

one of the infrared cable's 2# transmis-

sion diodes.

Now remove the 2 protective foils from •

the adhesive pad and attach the trans-

mission diode to the infrared receiver

of your signal source.

Note:

Avoid attaching the full length of the

transmission diode to the infrared

receiver of the signal source. Other-

wise it is possible that direct remote

control commands will no longer be

received.

Proceed in the same manner to con-•

nect further signal sources and/or

other devices that you want to control

with the radio transmission set.

Insert the cable plug of one of the •

supplied wall plug transformers 1( into

the connection socket for the supply

voltage o.

Insert the wall plug transformer • 1( into

a properly connected 230 V

~

/ 50 Hz

mains power socket.

Using a computer as the signal

source

You can also transmit the video signal of

a computer if the computer's video card

has a VIDEO output available.

IB_KH2130_DT35269_LB3C.indb 7IB_KH2130_DT35269_LB3C.indb 7 04.09.2009 13:08:58 Uhr04.09.2009 13:08:58 Uhr

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 24 25

Comments to this Manuals

No comments