Silvercrest KH 2130 User Manual download pdf (Page 10)

- 8 -

For the sound transmissions use, if neces-

sary, the AUDIO adapter 3,5 mm jack on

CINCH sockets 2$, which you connect to

the output of the sound card if this has

no cinch output. The yellow plug of the

CINCH—3,5mm jack cable 2) you con-

nect to the video card's video output.

Tips:

The video card must have an FBAS

output available.

Make sure that the computer is cor-

rectly configured for outputting video

on the video card.

Connecting the receiver

Connect the Audio/Video CINCH out-•

puts h of the receiver d to the A/V in-

puts on the target device, probably a

television set. For this you use the sup-

plied three core CINCH cable 2%. If

necessary, with the aid of the supplied

SCART—CINCH adapter "IN" 2!.

Note:

Be sure to match the colours correctly.

Insert the cable plug of the second •

supplied wall plug transformer 1( into

the connection socket for the supply

voltage j.

Insert the wall plug transformer • 1( into

a properly connected 230 V

~

/ 50 Hz

mains power socket.

Important!

Try, if required, to operate the receiver d

in various locations to avoid cancella-

tion effects and interference and thus

improve the transmission quality.

Switching on

Move the ON/OFF switch • a and k

of the transmitter and receiver to the

"ON" position to switch them both on.

Switch the signal source on and, if •

necessary, start playback.

Switch the TV (target device) on and •

activate the A/V inputs to which you

have connected the receiver.

Select on the transmitter and on the •

receiver, via the CHANNEL switch s

and l, implicitly in each case the

same transmission channel. The radio

transmission should now function.

Note:

The data/signals sent from the transmit-

ter are not encrypted. This means that

compatible devices within the recep-

tion range are capable of eavesdrop-

ping on the signal. The radio transmis-

sion set uses an "open standard".

To switch the signal source AV 1 and/•

or 2 for a TV connected to the trans-

mitter q press the button "ROOM 1" e

(= the room in which the transmitter is

located).

To switch the signal source AV 1 and/•

or 2 for a TV connected to the receiver

d press the button "ROOM 2" r

(= the room in which the receiver is

located).

Point the remote control of the signal •

source to the infrared receiver f of

the receiver d. The commands are

sent to your signal source.

IB_KH2130_DT35269_LB3C.indb 8IB_KH2130_DT35269_LB3C.indb 8 04.09.2009 13:08:58 Uhr04.09.2009 13:08:58 Uhr

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 24 25

Comments to this Manuals

No comments