Silvercrest SFR 3.7 A2 User Manual download pdf (Page 39)

SFR 3.7 A2

Prior to ﬁ rst use

Assembling the appliance

1) Remove all packaging materials from the

appliance.

2) Push the vacuum attachment 1 onto the

connecting piece 2.

NOTE

► This appliance is supplied with non-charged

batteries. The batter

ies must be charged for

3.5 hours before the ﬁ rst use.

3) Charge the appliance (see Chapter “Charging

the appliance”).

The appliance is now ready for use.

Operation

ATTENTION! DAMAGE TO PROPERTY!

► Do not use foaming, corrosive, aggressive,

abr

asive or chemical cleaning agents.

These can damage the appliance.

1) Set the tip of the spray nozzle q to STREAM

(ﬁ ne water mist) or SPRAY (coarse water mist).

2) Attach the spray nozzle q to the wiping attach-

ment 0.

3) Place the positioning ring w over the tube and

put it onto the spray nozzle q so that it clicks

into place.

4) Fill the spray bottle with water and, if desired,

with a cleaning agent suitable for window

cleaning e.

5) Screw the spray nozzle q with the ﬁ tted

wiping attachment 0 onto the spray bottle e.

6) Pull the microﬁ bre attachment z over the

retainer on the wiping attachment 0 and

secure it with the velcro fastener.

7) Spray the surface that you wish to clean.

8) Using the microﬁ bre attachment, z wipe over

the sprayed areas and loosen any stubborn

dirt.

9) Press the on/oﬀ switch 6. The indicator light 8

lights up red.

NOTE

► If the indicator light 8 ﬂ

ashes red during

use, this indicates that the appliance needs

to be charged (see chapter on "Charging the

appliance").

10) Move the blade of the vacuum attachment 1

slowly from top to bottom across the wet

surfaces. The moisture is removed and sucked

into the dirt container 5.

NOTE

► Never drag the blade sideways across wet

sur

faces. Doing so prevents the water from

being vacuumed up; instead, it runs oﬀ the

side of the blade.

11) After you have ﬁ nished a section, always start

again at the top.

ATTENTION! DAMAGE TO PROPERTY!

► Only continue working until the MAX mark

on the dir

t container 5 is reached. Then

switch oﬀ the appliance and empty the dirt

container 5.

Remove the plug on the dirt container 5.

Pour away the dirty water and reclose the dirt

container 5. You can then resume working.

12) Once the entire surface is dry, press the on/

oﬀ switch 6 again to switch the appliance oﬀ .

The indicator light 8 goes out.

13) If necessary, dry oﬀ any streaks or remaining

moisture on the surface with a dry cloth.

Charging the appliance

NOTE

► Ensure that the appliance is switched oﬀ

befor

e starting to charge the batteries.

■ To charge the appliance, connect the charger t

to a mains sock

et and insert the connecting jack

r into the charging socket 9 on the motor unit 7.

The indicator light 8 lights up red. When the

appliance is fully charged, the indicator light 8

lights up green.

1 ... 38 39 40 ... 54

Comments to this Manuals

No comments

Silvercrest SFR 3.7 A2 User Manual Page 39

Comments to this Manuals

Related products and manuals for For Home Silvercrest SFR 3.7 A2