Silvercrest SNMD 33 A1 User Manual download pdf (Page 66)

66

GB / IE

Monogramming and embroidering with embroidery hoop*

Attach the darning plate

Preparation for Monogramming and

Embroidering*

- Remove the presser foot and the presser

foot holder.

- Attach the darning plate.

- Lower presser foot lever before starting to

sew.

- Adjust the stitch width according to the

size of lettering or design.

- Draw the desired lettering or design on

the right side of the fabric.

- Stretch the fabric between embroidery

hoop as firmly as possible.

- Place the fabric under the needle. Make

sure the presser foot bar is down in its

lowest position.

- Turn the balance wheel towards you to

bring up the lower thread through the

fabric. Sew a few securing stitches at the

starting point.

- Hold the hoop with thumb and forefingers

of both hands.

- Coordinate sewing speed and movement

of hoop.

Stitch Stitch width Stitch length

B1~50

Stitch Stitch width Stitch length

B 3~5 0.5~1

Applique

* Embroidery hoop not included with machine.

- Cut out the applique design and baste it to

the fabric.

- Sew slowly around the edge of the design.

- Trim excess material outside the stitching.

Make sure not to cut any stitches.

- Remove the basting thread.

- Tie top and bottom thread under the

applique to avoid unraveling.

Sewing basics

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 72

Comments to this Manuals

No comments