Silvercrest SNMD 33 A1 User Manual download pdf (Page 55)

GB / IE 55

Attaching the presser foot holder

Attention:

2. Attaching the presser foot

3. Removing the presser foot

4. Attaching the edge/ quilting guide

Turn power switch to off ("O") when

carrying out any of the above operations!

1. Raise the presser bar (a) with the

presser foot lifter. Attach the presser foot

holder (b) as illustrated.

Lower the presser foot holder (b) using

the presser foot lifter, until the cut-out (c)

is directly above the pin (d)

The presser foot (f) will engage

automatically.

Raise the presser foot using the presser

foot lifter.

Raise the lever (e) and the foot

disengages.

Attach the edge/ quilting guide (g) in the

slot as illustrated.

Adjust as needed for hems, pleats,

quilting, etc.

Setting spool pins

The spool pins are used for holding the

spools of thread when feeding the thread to

the machine.

To use, pull up the spool pins. Push down

for storage.

A. Upper thread

B. Hole

C. Tangle

D. Spool pin

When using thread which has tendency

to tangle around a spool pin (D), thread

through the hole (B) of spool pin as

shown. The hole should face the thread

spool.

Note:

Getting ready

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 71 72

No comments

Silvercrest SNMD 33 A1 User Manual Page 55