Silvercrest SNMD 33 A1 User Manual download pdf (Page 62)

GB / IE

Blind hem foot

For hems, curtains, trousers, skirts, etc.

Blind hem/ lingerie for firm fabrics.

Fold the fabric as illustrated with the wrong

side uppermost. (1)

Place the fabric under the foot. T urn the

handwheel forwards by hand until the needle

swings fully to the left. It should just pierce

the fold of the fabric. If it does not, adjust the

stitch width accordingly. (2)

Adjust the guide (3) by turning the knob (4)

so that the guide just rests against the fold.

Sew slowly, by pressing the foot control

lightly guiding the fabric along the edge of

the guide.

Stitch Stitch width Stitch length

D1~23~5

Button sewing foot

Install the darning plate. This will cover the

feed dog and the stitch length will be

disabled

Position the work under the foot. Place the

button on the marked position, lower the

foot, adjust stitch width to "0" and sew a few

securing stitches. Adjust the stitch width

. Turn the

handwheel to check that the needle goes

cleanly into the left or right hole of the

button, and sew on the button. Adjust the

stitch width to "0" and sew a few securing

stitches.

If a shank is required, place a darning

needle on top of the button and sew. For

buttons with 4 holes, sew through the front

two holes first, push work forward and then

sew through the back two holes as

described.

according to the button

Stitch Stitch width Stitch length

B0~50

Sewing basics

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 71 72

No comments

Silvercrest SNMD 33 A1 User Manual Page 62