Silvercrest SFS 110 A1 User Manual download pdf (Page 60)

SFS 110 A1

NOTE

►

The bag opening must lie ﬂ at on the welding wire 4. Otherwise the weld-

ing does not work properly.

4) Close the appliance lid 1. The press seal 0 presses the bag onto the welding

wire 4, to create a smooth seam. Ensure that both corners of the appliance

lid 1 click closed. If necessary, press them down once again on the markings

and so that the appliance lid 1 clicks into place and locks shut.

5) Press the

button w. The red control lamp q lights up. As soon as the

sealing process is ﬁ nished, the red control lamp q goes oﬀ .

NOTE

►

You can halt the sealing process at any time by pressing the button e.

The red control lamp q goes out.

CAUTION – PROPERTY DAMAGE!

If the red control lamp q does not go out after a maximum of

10 seconds, there is a fault with the appliance.

► Remove the plug from the mains power socket immediately. Do not attempt

to repair the appliance yourself. Contact the Customer Service department.

6) Open the appliance lid 1 and remove the bag. This is now welded at one end.

NOTE

►

Ensure that the weld seam is properly closed. A correct weld seam should

be a smooth, straight stripe without any creases.

7) Fill the bag. You must leave at least 6 cm of the bag free up to the edge to

be welded.

CAUTION – PROPERTY DAMAGE!

►

Fill the bag so that no food scraps or liquids can leak out during welding

and get into the appliance.

8) If you do not want to vacuum the bag, you can now weld the other, open side.

IB_104351_SFS110A1_LB5.indb 57 03.12.14 16:11

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 79 80

No comments

Silvercrest SFS 110 A1 User Manual Page 60