Silvercrest Z31131 User Manual download pdf (Page 11)

11 GB

Preparing the product for use / Cleaning, care and storage

Switch the device on by pushing the ON / OFF switch

upwards.

Carefully insert only the tip of the nose and ear hair trimmer attachment

into the front area of your nostril or ear. Remove the nose or ear hair

with small circular movements.

After using the trimmer, switch the device oﬀ by pushing the ON / OFF

switch downwards.

Cleaning, care and storage

Note: Always switch oﬀ the product before cleaning it.

Do not use any corrosive or abrasive cleaning agents. These might

damage the surface of the product.

Take the nose and ear hair trimmer attachment

oﬀ and clean it

carefully under running water as shown in Fig. C. Then fully dry the

nose and ear hair trimmer attachment before re-installation.

Attention: The product is only protected against splash water. Never

immerse it in water. Otherwise, irreparable damage may result.

If there are still hairs in the the nose and ear hair trimmer attachment,

clean it with the a soft brush.

Occasionally place one or two drops of oil onto the blade

and

distribute the oil evenly (see Fig. D).

Only use an acid-free oil suitable for electric razor appliances.

To store the device, always put on the protective cap

Keep the device in a cool, dry location.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 63 64

No comments

Silvercrest Z31131 User Manual Page 11