Silvercrest H-8666 User Manual download pdf (Page 33)

31

GB

• Disconnect the mains plug from the wall

socket…

… if there is a fault,

… if you are not using the hand blender

and

… during thunderstorms.

• Do not use the device if there is visible

damage to the device or the power ca-

ble.

• To avoid any risk, do not make modifi-

cations to the device. You also must not

replace the power cable yourself. Re-

pairs must be carried out by a specialist

workshop or the Service Centre.

DANGER! Risk of injury

from cutting

• Never reach into the rotating blades. Do

not touch rotating parts with spoons or

similar utensils. Keep long hair or loose

clothing away from rotating parts as

well.

• The blade continues to rotate after the

device is switched off. Wait until the

blade has come to a standstill before

you pull the hand blender out of the

food.

WARNING! Risk of material

damage

• The device is designed for a maximum

operating time of 1 minute without inter-

ruption. After this, the device must re-

main switched off until it has cooled

down to room temperature.

• In order to prevent damage to the de-

vice, interrupt the blending process im-

mediately if the blade is either turning

with difficulty or not turning at all. Pull

out the mains plug and check whether

there is something in the vessel blocking

movement or whether the food is too

tough. Also check whether the device is

assembled correctly.

• Only use the original accessories.

• Do not use any astringent or abrasive

cleaning agents.

4. Items supplied

1 Motor unit 4

1Blender 5

1 Set of operating instructions

5. Installation

• Remove all packing material.

• Check to ensure that all parts are pre-

sent and undamaged.

• Clean the device prior to its first

use! (see “Cleaning” on page 32.)

DANGER! Risk of electric

shock! Only plug the mains plug 1

into the wall socket if the motor unit 4

has been connected to the blender 5.

Connecting the blender

(FigureA)

1. Place the motor unit 4 on the blender 5

in such a way, that the attachment mark-

ings 6 point to each other.

2. Turn the blender 5 in such a way, that

the attachment marking 6 on the

motor unit points to the lock mark-

ing 7. The motor unit 4 must engage

noticeably and audibly.

Removing the blender (Figure B)

•

To remove, turn the blender

5

in the op-

posite direction, so that the attachment

marking points

6 to the lock marking

7 and pull the motor unit 4 off from

the blender 5.

__RP88838_B2.book Seite 31 Montag, 4. März 2013 12:28 12

1 2 ... 28 29 30 31 32 33 34 35 36 37 38

Comments to this Manuals

No comments