Silvercrest SPW 180 C3 User Manual download pdf (Page 8)

5

SPW 180 C3

GB

CY

Initial operation

1) Open the battery compartment 2 by sliding

the cover in the direction of the arrow and then

removing it.

2) Insert the battery into the battery compart-

ment 2 according to its polarity.

3) Slide the cover back on to the battery compart-

ment 2 until it clicks into place.

4) Place the scales on a ﬂ at, ﬁ rm surface and tap

the centre of the scales with your foot to switch

it on.

5) Pick up the scales and set the desired unit of

measurement (kg, lb or st) by pressing the

UNIT button 1 on the rear of the scales

NOTE

► The unit of measurement must only be set on

ﬁ

rst use.

6) Place the scales on a ﬂ at and stable surface.

Ensure that neither the ﬂ oor at the location of

the scales nor the upper surface of the scales

are wet, otherwise there is a risk of slipping!

NOTE

► These scales contain sensitive electronic

components and should ther

efore NOT be

located:

– close to sources of heat

– in environments with extreme air humidity.

The scales ar

e now ready for use.

Using the scales

WARNING! RISK OF INJURY!

Never use the scales if they are wet

or moist. Never step onto the scales

with wet or moist feet. There would

be a serious risk of slipping and

personal injury!

Never put weight onto only one

side of the scales. Always step onto

the scales in the middle and with

both feet. Otherwise, the scales

could tip and become irreparably

damaged. There is also a risk of

falling over!

ATTENTION! DAMAGE TO PROPERTY!

► Never jump onto glass scales! This could

irr

eparably damage them.

1) Tap your foot on the middle of the scales to

switch them on.

2) Stand with both feet on the scales. Stand as

still as possible and without displacing your

weight.

3) During the weighing process, the indicated

weight increases until your weight is shown.

4) Once your weight has been determined, the

result blinks three times on the display 3.

NOTE

If the display 3 switches oﬀ

during weighing,

the scales cannot measure the weight correctly.

In this case, step down from the scales, wait

a few seconds and then try again. Make sure

you stand still and do not interrupt the weighing

procedure.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 51 52

Comments to this Manuals

No comments