Silvercrest STG 70 B2 User Manual download pdf (Page 10)

23. Turn the cover plate around again and push it into posi-

tion from the front. In the process, make sure that the

semicircular cut-outs under the cover plate engage

exactly into the two round brackets on the front edge of

the appliance. Check that the cover plate is fitted

securely by testing whether it is possible to pull the front

page upwards. If so, repeat this step.

24. Fasten the cover plate to the rear panel with the two

screws.

25. Position the appliance in its proper place, align it horizon-

tally using the feet and finally check that the door is

straight.

10. Troubleshooting

If your device fails to function as required, please try this

checklist first. Perhaps there is only a minor problem and you

can solve it yourself.

DANGER! Do not attempt to repair the appliance

yourself under any circumstances.

11. Technical data

Subject to technical modifications.

Fault Possible causes/Action

No function

• Is the appliance being supplied with

power?

• Is the appliance switched on?

Unusual noises

• Gentle noises caused by the motor

and the flow of refrigerant in the lines

are quite normal.

• Check whether the appliance is posi-

tioned firmly and horizontally. If neces-

sary, align the appliance with the

height-adjustable feet 6.

• Is the appliance touching other objects

or the wall?

A layer of ice

forms quickly in

the appliance.

• Was the door left open for a long time

or frequently during operation?

• Check whether the door seal is clean

and is in air-tight contact all the way

round.

• Check whether the appliance is posi-

tioned firmly and horizontally. If neces-

sary, align the appliance with the

height-adjustable feet 6.

The tempera-

ture in the appli-

ance is too high.

• Has the door been left open?

• Have you frozen fresh foods in the last

24 hours? Was the quantity too large?

Were the foods too warm? If you have

not already done so, set the tempera-

ture controller 1 to SUPER.

• Check the setting of the temperature

controller 1. If necessary, select a

higher temperature level.

• Check the installation location: Is there

an oven, another cooling device or a

different heat source nearby? Is the

ambient temperature too high?

• Check the clearances around the ap-

pliance. Can the air circulate ade-

quately around the appliance?

It is difficult to

open the door.

• This is normally if you have already

opened the door shortly beforehand. A

vacuum is formed in the appliance due

to the cooling of the air, which is com-

pensated for again within a few min-

utes.

Door cannot be

closed.

• Check whether all the drawers are in

their correct position.

The refrigerant

circuit has been

damaged.

• Ventilate the room thoroughly, discon-

nect the power plug and keep all

sources of ignition and naked flames

at a distance without fail. Please con-

sult the Service Centre.

The door seal is

deformed or

damaged.

• Please consult the Service Centre.

Model: STG 70 B2

Mains voltage: 220 - 240V ~ 50Hz

Protection class: I

Refrigerant R 600a (35 g)

Insulation gas Cyclopentane

Power 70 W

Energy consumption 127 kWh/annum

Gross capacity 86 L (with all drawers removed)

Useful capacity (net) Approx. 83 L (available space in

the drawers)

Freezing capability 4 kg/24h

Climate classification ST, N

Weight 33.5 kg

Dimensions 84.5 cm x 54.5 cm x 57.4 cm

(H x W x D)

Fault Possible causes/Action

__RP62026_B4.book Seite 8 Dienstag, 8. Februar 2011 11:34 11

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 61 62

Comments to this Manuals

No comments

Silvercrest STG 70 B2 User Manual Page 10

Comments to this Manuals

Related products and manuals for Refrigerators Silvercrest STG 70 B2