Silvercrest SDS 3000 A1 User Manual download pdf (Page 8)

SDS 3000 A1

Securing devices

NOTICE

This tripod is equipped with a quick release plate ► 2. When a device is

screwed onto the quick release plate 2 you can, by sliding the locking

device 8 on the side of the tripod plate 3, loosen the device together

with the quick release plate 2 from the tripod plate 3. Thus, you do not

always have to unscrew the device from the thread 1.

Remove the quick release plate 1) 2 from the tripod. For this, slide the locking

device 8 to the side so that you can lift the quick release plate 2.

Screw the required device onto the quick release plate 2) 2. To do this, turn

the screw - with the help of the handle on the underside of the quick release

plate 2 - until the device is ﬁ rmly seated.

To replace the quick release plate 3) 2 complete with the device back on

the tripod plate 3, slide the locking device 8 to the side and reposition

the quick release plate 2. Then secure the locking device 8, such that the

quick release plate 2 is ﬁ rmly seated.

Using the tripod

When you have set the tripod up and the device is mounted on it, you can then

adjust it as follows:

WARNING - PROPERTY DAMAGE!

Always hold the grip ► 0 ﬁ rmly when you loosen the locking screw “High”

7 and turn the crank q. Otherwise – if the locking screw “High” 7 is

loosened and the crank q is not ﬁ rmly held - the rod with the attached

device could fall down to the lowest setting and, through it, the device

could be damaged.

Loosen the locking screw “High” ■ 7 to a point where the crank q can be

turned easily. Turn the crank q to adjust the height. When the desired height

has been reached, ﬁ rmly retighten the locking screw “High” 7.

To swivel the device horizontally through up to 360°, loosen the locking

■

screw "360°" 5. Take hold of the grip 0 and swivel the tripod plate 3.

When you have reached the desired position, retighten the locking screw

"360°" 5 ﬁ rmly.

To adjust the tilt angle, rotate the grip

■ 0 and move it either up or down.

When the desired tilt angle has been reached, rotate the grip 0 again until

it is ﬁ rm.

IB_71271_SDS3000A1_LB3.indb Abs3:6IB_71271_SDS3000A1_LB3.indb Abs3:6 12.10.2011 9:19:37 Uhr12.10.2011 9:19:37 Uhr

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

No comments

Silvercrest SDS 3000 A1 User Manual Page 8