Silvercrest SFS 110 A1 User Manual download pdf (Page 11)

SFS 110 A1

Welding a tube ﬁ lm

NOTES ON THE FILM

►

The ﬁ lm width may not exceed 28 cm. Otherwise it cannot be welded

correctly.

► Use only nylon-PE ﬁ lms with a structure (points or grooves) on one side and

that have a structure (points or grooves) on one side and a thickness of

approximately 0.17 - 0.29 mm (170 - 290 μ).

Otherwise the weld seam will not be tight and the appliance may be da-

maged. You can recognise ﬁ lms of this type from the information on the

packaging. The quality of the weld seam will vary depending on the type

and thickness of the ﬁ lm.

► The supplied ﬁ lm is suitable for temperatures between -20°C and +100°C.

1) Cut the desired length for your bag from the tube ﬁ lm using a pair of scissors.

Cut as straight as possible.

2) Open the appliance lid 1 by pressing the lid release 8 and opening the

lid 1 upwards.

3) Lay the open end of the bag as far into the appliance so that the opening of

the bag is located centrally under the lower sealing ring 5. The bag should

be inserted no further than the rear limiters 6 and must lie between the front

limiters 7. If the bag lies over one or both of the two limiters 7, then the

bag cannot be correctly welded.

IB_104351_SFS110A1_GB_IE_CY.indb 8 03.12.14 15:08

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 53 54

No comments

Silvercrest SFS 110 A1 User Manual Page 11