Silvercrest SHBS 500 B1 User Manual download pdf (Page 10)

6. Operation

Regardless of the charging state of the battery, the hair and beard trimmer can

always be mains-operated.

1. Before switching to mains operation, ensure that the device is switched off.

2. Connect the power unit to the connection7 of the device.

3. Insert the power unit into a readily accessible wall socket whose voltage

matches the voltage stated on the rating plate.

4. Switch on the device with the on/off switch5.

6.1 Pushing on/removing the comb attachments

WARNING! Risk of injury!

Switch off the device before replacing or changing the comb attachments.

Pushing on

• In order to attach a comb attachment, push this over the guide rails on the

side of the device onto the comb attachment fastener4, until it is heard to

click into place.

Removing

1. Figure A: To change the comb attachments, turn the device onto its back.

2. Figures B/C: Push the comb attachment1 upwards together with the slid-

er10. Push the comb attachment carefully upwards with moderate force us-

ing your thumb and index finger beyond the side locking pins. The comb

attachment is released from the comb attachment fastener4.

3. Remove the comb attachment.

6.2 Cutting hair

NOTES:

• The hair to be dressed must be dry.

• The cutting length may deviate depending on the cutting angle.

• Place a sheet or cape around throat and neck to prevent cut-off hair from

dropping into the collar.

• Comb the hair well.

• First, start with a comb attachment with a longer cutting length and then, in

the course of the cutting process, use shorter cutting lengths step by step. Ad-

__GRA93480_B6.book Seite 8 Montag, 9. September 2013 10:41 22

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 51 52

No comments

Silvercrest SHBS 500 B1 User Manual Page 10