Silvercrest SVW 50 A1 User Manual download pdf (Page 30)

28

5. Before using for the first time

1. Unpack the appliance carefully from the

packaging and remove the packing

material.

2. Place the appliance on a level, dry

surface.

3. Insert the mains plug into a suitable

mains socket (see “3. Technical data”

on page 26).

6. Operation

Caution!

The cover 5 is for service use only. In

operation, it must always be tightened in

order to prevent possible damages.

6.1 Switching on/off

Switching on:

Turn the On/Off switch 3 to "ON".

Switching off:

Turn the On/Off switch 3 to "OFF".

6.2 Setting the blower setting

The blower settings are used to select how

fast the appliance circulates air in the room.

The appliance has four blower settings.

Set the desired blower setting by turning the

blower settings switch 1 to the desired

setting.

Note: The individual blower settings each

exist twice. Turn the blower settings switch 1

clockwise if you wish to start with a low

blower setting and turn it anti-clockwise if

you wish to start with a high blower setting.

6.3 Setting the running time

The appliance has a timer which you can

use to set the desired running time to

between 0 and 120 minutes.

1. Switch on the timer by turning rotary

switch 3 to any time between 0 and 120

minutes. The power supply is switched on

at the same time.

2. To switch off the timer, set rotary

switch 3 to "OFF".

Note If you want the appliance to operate

continuously, set rotary switch 3 to "ON".

6.4 Setting the angle of tilt

Caution! Never pivot the vent grille 2 by

hand. This could damage the appliance.

The tilt angle can be set by pivoting the vent

grille 2:

1. Activate the pivoting vent grille 2 by

setting the switch 4 to "MOVE".

The vent grille 2 will pivot and distribute

the air evenly within the room.

2. If you desire a specific tilt angle, wait for

the vent grille 2 to move into the

corresponding position and then set the

switch 4 to "STOP".

Note: If you have selected position "0" for

the blower settings switch 1, the vent grille 2

will also stop pivoting.

6.5 Transport

1. Check that the appliance is switched off

before transportation.

RP86377 Standventilator LB2 Seite 28 Dienstag, 22. Januar 2013 5:06 17

1 2 ... 25 26 27 28 29 30 31 32 33 34

Comments to this Manuals

No comments