Silvercrest KH 2389 Service Manual download pdf (Page 22)

- 20 -

 Tips:

1. Do not use the following buttons for the learn function: all

device buttons e, MACRO i, S button r, EXIT y.

2. If when teaching, during the notice "LEARNING", no

button is pressed on the original RC after 25 seconds the

learn menu will end. This mode can not be ended

by pressing a button on the URC.

3. The memory can accommodate 150 button commands.

If the memory is full the LCD display q shows "LEARN

FULL" and the learn mode will end.

4. With the EXIT button y you return to the previous status

(except with a notice of "LEARN KEY" and/or "LEARNING").

Code learn function

1. Press the device button e for the device that the URC

should learn a button code.

2. Hold down the S button r for a little longer than 3 sec-

onds. The notice "LANGUAGE SETUP" appears.

3. With the  or  button t select the menu "LEARN

SETUP" and then press the OK button l.

4. In the LCD display q "LEARN SET" appears. Then press

the OK button l.

In the LCD display q "LEARN KEY" ap-

pears.

5. First press the button on the URC that is to be taught. In the

LCD display q "LEARNING" appears. The URC now waits

for the infrared signal from the original remote control.

Note:

Should the notice not change to "LEARNING" you have

selected a button for which no button code can be

taught.

6. Point the infrared sensors 2) of both remote controls

towards each other.

7. Now hold down the desired button of the original

remote control until "SUCCESS" or "LEARN ERROR"

appears in the display q of the URC.

8. If in the LCD display q "SUCCESS" appears (process

successful), you can teach further buttons begining with

step 5. If "LEARN ERROR" appears (process unsuccessful)

repeat the process in any case from step 5.

9.

To stop/end the learn process press the S button and

subsequently, while “LEARN KEY” is displayed, repeatedly

the EXIT button y until the normal indicator appears in the

LCD display q. During the displayed “LEARNING” simply

allow 30 seconds to pass without any operation and the

device will then exit the menu.

Delete all programmed buttons of all devices

1. Hold down the S button r for a little longer than 3 sec-

onds. The notice "LANGUAGE SETUP" appears.

2.With the  or  button t select the menu "LEARN

SETUP" and then press the OK button l. In the LCD

display q "LEARN SET" appears.

BDA_SFB 10.1 B2 - DT-71477_gb.indd 20 23.11.2011 16:24:25

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 108 109

Comments to this Manuals

No comments

Silvercrest KH 2389 Service Manual Page 22

Comments to this Manuals

Related products and manuals for Car media receivers Silvercrest KH 2389