Silvercrest SKD 2300 A1 User Manual download pdf (Page 56)

54

3. Press the “Reduce temperature” button 17

to lower the desired temperature to a

minimum of 5 °C (41 °F).

Selected speciﬁed temperature 20 is

shown in display 5.

6.3 Setting the heat setting

The appliance has three heat settings:

– 1,000 watts

– 1,300 watts

– 2,300 watts

1. Press button 25 repeatedly until the

desired heat setting is set.

Selected heating level 11 is shown in

display 5.

2. Press the fan button 15 to switch the fan

on or off.

If the fan is switched on, "Fan"

symbol 12 is shown in display 5.

Note: The fan might make a slight noise,

but it does ensure better circulation of

the heated air.

6.4 Setting the heating time

The appliance has a timer for setting the

heating time to between 1 and 15 hours.

The appliance switches off automatically

once the heating time has expired.

1. Press timer button 18 repeatedly until

desired running time 19 is shown in

display 5.

2. To switch off the timer, press timer

button 18 repeatedly until running time

19 is no longer displayed.

6.5 Thermal cut-out

For your safety the appliance has a thermal

cut-out.

If the temperature inside the appliance

becomes too high, the appliance switches

off automatically:

1. Switch the mains switch 9 to "0" to

switch off the appliance.

2. Check whether the air inlet 6 or outlet 4

is obstructed and remove the cause.

If you cannot establish a cause and the

fault occurs repeatedly, have the

appliance repaired or else take it out of

use.

3. Wait for the appliance to cool down.

4. You can then continue to operate it

normally.

6.6 Frost protection

To prevent the temperature in a room falling

below 0 °C (32 °F), proceed as follows:

1. Press the button for selecting heating

level 25 repeatedly until "Frost

protection" symbol 13 appears in

display 5.

As soon as the temperature in the immediate

vicinity of the appliance drops signiﬁcantly

below 7 °C (44 °F), the heating

automatically switches on.

As soon as the temperature rises to above

9 °C (48 °F), the heating switches off and

display 5 shows room temperature again.

2. To switch off frost protection, press the

button for selecting heating level 25

repeatedly until "Frost protection"

symbol 13 in display 5 disappears.

RP74308 Konvektor LB1 Seite 54 Dienstag, 26. Juni 2012 12:07 12

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 62

Comments to this Manuals

No comments