Silvercrest SKD 2300 A1 User Manual download pdf (Page 55)

SKD 2300 A1 53

Warning! Ensure that there is

sufﬁcient distance from the wall,

ﬁxtures and other appliances. The

distance must be at least 1 m to

exclude the risk of ﬁre.

1. Select a location in compliance with the

safety information (see “4. Safety

information” on page 49).

2. Plug the mains plug into a wall socket

that complies with the technical data.

Note:If you have plugged other power

consumers into the same circuit, check

that the maximum load for the installed

fuse is not exceeded, as otherwise the

fuse will trip.

5.3 Inserting the batteries

If the appliance is new or the batteries in the

remote control are ﬂat, new type AAA/LR03

batteries must be inserted.

1. Push off the battery compartment cover

on the underside of the remote control.

2. Remove the old batteries if present.

Note: Please observe the instructions for

disposal (see “9.2 Disposable/

rechargeable batteries” on page 56).

3. Insert new batteries.

Note: Ensure the correct polarity (+/–).

The correct polarity is shown on the

bottom of the battery compartment.

4. Close the battery compartment again.

6. Operating

6.1 Using the appliance for the ﬁrst

time

1. Plug the mains plug into a wall socket

that complies with the technical data (see

“3. Technical data” on page 49).

2. Switch the mains switch 9 to ON to

switch on the power supply.

The lamp in the main switch 9 lights up

and you hear a beep.

3. Press the On/Off button 22 to switch the

appliance on.

The display 5 lights up.

The appliance is now ready for use and can

be operated by means of the remote control

or control panel 2.

6.2 Selecting the temperature

Notes:

• Temperature display 20:

– set speciﬁed temperature

• Temperature display 21:

– measured actual temperature

• Temperature is measured directly at the

appliance using temperature sensor 8. It

may be some time before the entire

room has also reached this temperature.

1. To choose whether you wish the

temperature to be displayed in °C or °F,

press button 24.

Selected unit of measurement 14 is

shown in the display 5.

2. Press the “Increase temperature” button 16

to increase the desired temperature up to a

maximum of 37 °C (99 °F).

Selected speciﬁed temperature 20 is

shown in display 5.

RP74308 Konvektor LB1 Seite 53 Dienstag, 26. Juni 2012 12:07 12

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 61 62

Comments to this Manuals

No comments