Silvercrest SHBS 1000 A1 Service Manual download pdf (Page 15)

15 GB/IE

Before first use / Use

j Insert the connector plug of the plug-in mains adapter into the

socket on the underside of the hair and beard clippers.

j To avoid injury and damage to the device, always switch oﬀ the

device before you connect it to the mains supply.

j Insert the plug-in mains adapter (wide voltage range 100 - 240 V)

into a mains outlet socket that meets the requirements of the device.

j After 1 - 2 seconds you can switch on the device by pressing the

ON / OFF switch

. If the device does not start working immedi-

ately, switch it oﬀ again and wait for about 1 minute before you

switch it on again.

j If you wish to charge the batteries in this way without using the

charging station

, then do so only with the device switched oﬀ.

Use

Prolonging the life of the

rechargeable batteries

For a longer rechargeable battery service life, it is recommended that

the batteries are completely discharged before they are recharged. To

completely discharge the battery, run the device until it comes to a

complete stop.

Tips

The hair to be cut should be clean and dry.

j Comb your hair through carefully to remove any knots.

j Place the hairdresser’s cape or a cloth around the throat and neck

to prevent hair from dropping into the collar.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 24 25

No comments

Silvercrest SHBS 1000 A1 Service Manual Page 15