Silvercrest SKD 2300 A1 User Manual download pdf (Page 9)

SKD2300A1 7

• Do not short circuit the batteries.

• Remove the batteries if the device is not

used for a long time. Leaking batteries

could damage the device.

4.9 Material damage

Caution! To avoid material damage,

please observe the following conditions.

• Remove the batteries from the remote

control if you are not using it for a

prolonged period of time. Leaking

batteries could damage the remote

control.

• Ensure that the feet are fitted correctly

(see “5.1 Mounting the appliance” on

page 7), otherwise the floor might be

scratched or scorched.

5. Unpacking, setting up and inserting the batteries

5.1 Mounting the appliance

Before the appliance can be used, the feet 7

must be screwed on as follows:

1. Unpack the appliance from the

packaging.

2. Remove the transport packaging.

3. Check that the appliance shows no signs

of damage.

4. Slide the feet 7 from the outside into the

corresponding supports on the

underside of the convector.

5. Secure the feet 7 firmly using the screws

supplied.

5.2 Setting up the appliance

Note: As the appliance and heating

elements are supplied with a thin film of

grease, there might be a small amount of

smoke and odour the first time the appliance

is used. This is not harmful and will stop after

a short while. Please ensure meanwhile that

there is sufficient ventilation.

Warning! Ensure that there is

sufficient distance from the wall,

fixtures and other appliances. The

distance must be at least 1 m to

exclude the risk of fire.

1. Select a location in compliance with the

safety information (see “4. Safety

information” on page 4).

2. Plug the mains plug into a wall socket

that complies with the technical data.

Note:If you have plugged other power

consumers into the same circuit, check

that the maximum load for the installed

fuse is not exceeded, as otherwise the

fuse will trip.

5.3 Inserting the batteries

If the appliance is new or the batteries in the

remote control are flat, new type AAA/

LR03 batteries must be inserted.

1. Push off the battery compartment cover

on the underside of the remote control.

2. Remove the old batteries if present.

Note: Please observe the instructions

for disposal (see “9.2 Disposable/

rechargeable batteries” on page 10).

3. Insert new batteries.

Note: Ensure the correct polarity (+/

–). The correct polarity is shown on the

bottom of the battery compartment.

4. Close the battery compartment again.

RP100058 Konvektor LB4 Seite 7 Mittwoch, 30. April 2014 4:12 16

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 85 86

Comments to this Manuals

No comments