Silvercrest SHBS 1000 A1 Service Manual download pdf (Page 16)

16 GB/IE

Use

Cutting hair

Tip: Start with a cutting length comb attachment with a longer cutting

length than is ﬁnally required, then proceed in stages until you achieve

the desired length.

Cutting length comb attachments

j Select the cutting length comb attachment

(4 - 6 mm / 7 - 9 mm /

10 - 12 mm / 16 - 18 mm / 22 - 24 mm / 28 - 30 mm) to suit the desired

cutting length.

j Push the selected cutting length comb attachment

from the rear

on to the blade set

. Ensure that the two pins on the attachment

engage properly into the recesses in the sides of cutter head mount.

Note: By adjusting the setting of the sliding switch

you can

ﬁnely graduate the desired cutting length of the cutting length comb

attachments

. If you select the cutting length comb attachment

for a hair length of 22 - 24 mm and would like to cut your hair to

22 mm, then slide the sliding switch

for the ﬁne adjustment of

the cutting length as far as it will go upwards (0.5 mm). Stepping

the ﬁne adjustment setting switch downwards increases the cutting

length to 22.7 mm (with a ﬁne adjustment of 1.2 mm); to 23.4 mm

(with a ﬁne adjustment of 1.9 mm) or to 24 mm (with a ﬁne adjust-

ment of 2.5 mm).

Cutting length comb

attachment

(mm)

Cutting lengths*

with cutting length ﬁne adjustment (mm)

0.5 1.2 1.9 2.5

4 - 6 4.0 4.7 5.4 6.0

7 - 9 7.0 7.7 8.4 9.0

10 - 12 10.0 10.7 11.4 12.0

16 - 18 16.0 16.7 17.4 18.0

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 24 25

No comments

Silvercrest SHBS 1000 A1 Service Manual Page 16