Silvercrest SHBS 500 B1 User Manual download pdf (Page 67)

just the cutting length with the slider10 and read off the cutting lengths on

the marking8 on the side of the comb attachment1.

• Start by cutting the hair in the neck or on the sides and cut towards the cen-

tre of the head. Then, cut the front section of the hair towards the centre of

the head.

• Hold the device in such a way that the comb attachment lies as flat as pos-

sible on the head. Move the device evenly through the hair.

• If possible, cut against direction of hair growth.

• In order to catch all the hair, move the device several times through each

section of the hair.

• Comb the hair repeatedly and well.

• In order to achieve a straight cutting line for cutting lengths over 20 mm,

the device should be passed through the hair several times from different di-

rections.

6.3 Thinning hair

Use the thinning function to reduce the volume of the hair without changing its

length.

• Push the slider3 to the left. The thinning function integrated into the shav-

ing head9 is extended upwards.

6.4 Cutting hairlines and beard

WARNING! Risk of injury!

The points of the shaving head are sharp. Handle with care

• Adjust the cutting length with the slider10 according to the desired hair

length and read off the cutting length using the marking8 on the side of

the comb attachment1. Now, shorten your beard step-by-step.

• Use the device only with the shaving head9 and without comb attach-

ment, to cut hair very short or to cut beard and hairline. In this way you

can cut hair lengths of 1-2 mm evenly.

__GRA93480_B1.book Seite 65 Montag, 9. September 2013 10:20 22

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 75 76

No comments

Silvercrest SHBS 500 B1 User Manual Page 67