Silvercrest SFR 1200 A1 User Manual download pdf (Page 40)

40 GB/MT

Before first use / Cleaning and maintenance

Wet shave

Use a ﬁne-bubbled shaving foam.

CAUTION! We advise against the use of

shaving gel, as it can stick the foil

and the

cutter set

together.

Apply a thin layer of shaving foam to your

face. Shaving foam is the most suitable choice

from the wide range of available cosmetic

shaving products. Do not use a thick layer of

shaving foam, as this can detrimentally aﬀect

the performance of the shaver.

Proceed with the shave in all other respects as

described in the section “Foil shave”.

If the shaving head

becomes blocked, rinse

the shaver under running water (refer to the

section “Wet cleaning”).

Trimmer

The trimmer

on the back of the device can be

switched on by pushing it out into the locked position.

Slide the trimmer towards the shaving head

far as it will go.

It can be used for shortening longer beard hair,

trimming contours, sideburns and walrus moustaches.

After use, slide the trimmer

back into its initial

position.

3-day beard attachment

The supplied protective cap

can be used as a

3-day beard attachment. Regular use of this attach-

ment allows you to create the eﬀect of a three day

beard.

Note: Please note that using the 3-day beard at-

tachment produces a shave corresponding to anything

between a 3-day and a 7-day beard, depending

on the rate of growth of your beard.

Place the protective cap

on to the shaving

head

and ensure it engages. The trimmer

is now blocked by the protective cap

To switch on the device, slide the ON / OFF

switch

upwards. You can now trim your beard.

To switch oﬀ the device, slide the ON / OFF

switch

downwards.

Note: When you are using the protective

cap

as a 3-day beard attachment, the direct

contact of the foil with your skin is lost. The nat-

ural lubrication of the cutting system by the secre-

tions from your skin no longer takes place. After

each use of the 3-day beard attachment, spread

a drop of cutter or sewing machine oil on the

foil after cleaning. This will preserve the excellent

shaving performance of your shaver.

Take oﬀ the protective cap

if you wish to

have a “1-day shave” without using the 3-day

beard attachment, or if you wish to use the

trimmer

. Detach the protective cap

from

the shaving head

to do this.

Cleaning and maintenance

Cleaning

CAUTION! RISK OF ELECTRIC SHOCK!

Always disconnect the shaver from the mains

supply and the ﬂex before cleaning it. Do not

immerse into water or other ﬂuids!

Always clean the razor after each use in order

to ensure it works well.

When cleaning the appliance regularly with warm

water, occasionally moisten the long hair trim-

mer

and cutter set

with sewing machine

oil.

Dry cleaning:

CAUTION! Do not clean the foil with the brush

as this could damage it. Do not remove the foil!

Press the release buttons

on the side and

pull the shaving foil frame

out or blow it out.

Knock the shaving foil frame

out on an even

surface.

Brush the cutter set

with the cleaning brush.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 54 55

Comments to this Manuals

No comments

Silvercrest SFR 1200 A1 User Manual Page 40

Comments to this Manuals

Related products and manuals for Hair clippers Silvercrest SFR 1200 A1