Silvercrest KH 2398 User Manual download pdf (Page 7)

- 5 -

Fixing the kitchen radio beneath a

wall cabinet

With the supplied mounting plate q you can

x the kitchen radio below, for example, a

kitchen wall cabinet:

1. Determine a suitable location for the

kitchen radio.

2. Press the two retaining levers on the back

of the appliance down. Push the mounting

plate q back and remove it.

3. Hold the mounting plate q under the in-

stallation location. Thereby, the front edge

of the mounting plate q should be ap-

prox. 4 cm behind the front of the kitchen

cabinet (See fold-out illustration "B").

4. Mark the four points for the drillholes with

a pencil.

5. Using a spike, make a small depres-

sion at the marking points. Firmly secure

the mounting plate q with the supplied

screws.

6. Hold the kitchen radio slanted, with the

two recesses in the retaining lugs on the

mounting plate q. Press the kitchen radio

upwards until it perceptibly engages.

Disassembly

• To disassemble the kitchen radio, press

the two retaining levers at the rear of the

appliance downwards. Then pull the ra-

dio out to the front and remove it.

• Unscrew the screws and remove the as-

sembly plate q.

Setting up the kitchen radio

Do not set the kitchen radio up without the

mounting plate q. Otherwise the speakers are

covered and the sound is scarcely audible.

To t the kitchen radio with the supplied

mounting plate q:

1. Simultaneously press the two retaining

levers on the back of the appliance down.

Push the mounting plate q back and re-

move it.

2. Push the two rear retainer lugs on the

mounting plate q into the recesses on the

lower side of the kitchen radio.

3. Press the mounting plate q rmly into the

appliance underside until it perceptibly

engages.

Providing mains power

• When you have completed installation of

the appliance, insert the plug into a mains

power socket. The display o is illumi-

nated and the appliance tries to receive

an RDS signal to automatically adjust

the time and date.

• For as long as the appliance waits for

the RDS signal, the display o shows

"Please wait for setting thanks". This

can take several minutes. To hide this no-

tice, press the button MODE/

j.

The Settings menu

Setting the time

Should this not succeed, you must set the

clock manually. For this, the radio cannot be

switched on (= automatic mode).

1.

In automatic mode press the button

MODE/

j once. The time display

blinks.

2.

Press the buttons UP/DOWN 1(/l

to set the time in minute intervals. Pressing

and holding the button changes the time

at ten-minute intervals.

3.

Press the button MODE/ j once

again to save the time and switch to the

date setting.

If you do not press a button for 15 seconds

when making the settings, the appliance saves

the current setting and returns to automatic

mode.

Setting the date

1. In automatic mode press the button

MODE/ j twice. In the display o

appears "01.01.2010", the date display

ashes.

BDA_KH 2398 - DT-49029_6_uk.indd 5 22.06.2010 17:28:47

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments