Silvercrest SHIR 12 A1 User Manual download pdf (Page 51)

SilverCrest SHIR 12 A1

English - 49

When the headset (A) is not in use, it should be stored in the base (E) if possible.

Thus you know where to find it and the battery is always charged.

Cleaning / replacing ear pads

If necessary, you can clean the ear pads with a mild detergent

and lukewarm water.

2 pairs of replacement ear pads (F) are also supplied with the

device.

Proceed as follows:

First, remove the ear pads (1) to be cleaned or replaced from

the headset earpieces (2) and then attach cleaned or new ear

pads.

Troubleshooting

No reception

 Check whether the mains charger is correctly inserted into the mains socket.

 Check whether the mains charger plug is correctly inserted into the DC-IN socket (12) of the

base (E).

 Check whether the audio cable is correctly inserted into the audio source and the base (E).

Poor reception

 Plasma screens emit an infrared signal which may have a negative impact on the transmission

quality. Install the base (E) as far as possible from the plasma screen.

 The distance between the headset (A) and the base (E) is too great. Reduce the distance.

 There are objects between the base (E) and the headset (A).

 The built-in battery is almost empty. Charge the battery.

Sound only in one ear

 Check whether the 3.5mm jack plug of the audio cable (C) is correctly inserted into the base

(E).

 Check the setting of the stereo/mono switch (9).

Noise

 Make sure that there is visual contact between the base (E) and the headset (A).

1 2 ... 46 47 48 49 50 51 52 53 54 55 56

No comments

Silvercrest SHIR 12 A1 User Manual Page 51