Silvercrest PNA-E3510 Operations Instructions download pdf (Page 71)

- 69 -

The function "Rapid" is only available with

Programmes 1-4.

A bread weight level cannot be selected with the

Programmes 6, 7, 11 and 12.

10. You now have the option of setting the end time

of your programme using the timer function.

You can enter in a maximum time delay of up

to 15 hours.

 Note:

This function is not available for Programme 11.

Starting the Programme

Now start the programme with the Start/Stop button

.

 Note:

The Programmes 1, 2, 3, 4, 6, 8 and 9 start with a

10 to 30 minute pre-heat phase (except Rapid,

see Table for Programme Sequences). The knea-

ding paddles  do not move themselves. That is

not an error of the machine.

The Programme automatically carries out the

various operations.

You can watch the programme sequence via the

window  of your Bread Baking Machine.

Occasionally, condensation may collect in the win-

dow during baking . The appliance lid  can

be opened during the kneading phase.

 Note:

Do not open the appliance lid  during the rising

or baking phases. The bread could collapse.

Ending the Programme

When the baking process has been completed, ten

acoustic signals are sounded and the display 

indicates 0:00.

At the end of the programme the appliance auto-

matically changes to a keep-warm mode for up to

60 minutes.

 Note:

This is not applicable to Programmes 6, 7 and 11.

In this mode, warm air circulates inside the

appliance. The keep warm period can be

prematurely terminated by pressing down the

Start/Stop button  until the signal tone sounds.

 Warning!

Before opening the appliance lid  remove the

power plug from the wall socket.

When not in use, the appliance should never be

plugged in!

Taking out the bread

When handling the hot baking mould,  always

use pot holders or oven gloves.

Hold the baking mould  tilted over a grid and

shake it lightly until the bread slides out of the

baking mould .

If the bread does not slip off the kneading paddles

, carefully remove the kneading paddles 

using the supplied kneading paddle remover .

 Note:

Do not use any metal objects which may cause

scratches on the non-stick coating.

After removing the bread, immediately rinse the

baking mould  with warm water. This prevents

the kneading paddles  from sticking to the

driving shaft.

Tip: If you remove the kneading paddles  after

the last kneading of the dough, the bread will

remain intact when you remove it from the

baking mould .

IB_69294_SBB850A1_LB5 12.08.2011 13:19 Uhr Seite 69

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 105 106

Comments to this Manuals

No comments

Silvercrest PNA-E3510 Operations Instructions Page 71

Comments to this Manuals

Related products and manuals for Car navigation systems Silvercrest PNA-E3510