Silvercrest SMK 15 A1 User Manual download pdf (Page 7)

SMK 15 A1

5

4. Operating the Appliance

4.1 Using the appliance for the ﬁrst

time

1. For reasons of hygiene, clean the

appliance thoroughly inside and out

before using it for the ﬁrst time or if it

has not been used for a long time (see

“5.1 Cleaning the appliance” on

page 6).

2. Select a location that is well ventilated

and protected from heat and sunlight.

3. Place the appliance on a level, non-slip

surface.

4. Turn the function selector

6

and the

voltage selector

7

to the OFF position.

4.2 Selecting a voltage

Use the voltage selector

7

to select the

required voltage:

12V:

operating on a car electrical

system

230V:

operating on the mains

OFF

: appliance is switched off.

4.3 Connecting the appliance to the car

electrical system

Note:

When operated on a vehicle 12 V

system the cooling and warming

performance is not quite so high as when

operated on 230 V mains (see “7. Technical

Data” on page 8).

1. Plug the car lead

11

into the socket

8

.

2. Connect the car lead

11

to the car elec-

trical system, e.g. the cigarette lighter.

Note:

You may need to pull the red cap

off the car plug.

4.4 Connecting the appliance to the

mains

1. Plug the mains lead

3

into the socket

9

.

2. Connect the mains lead

3

with the mains

supply.

4.5 Selecting a function

Use the function selector

6

to select the

required function:

OFF:

appliance is switched off.

WARM:

appliance warms and the red

indicator

10

lights up.

COOL:

appliance cools and the green

indicator

5

lights up.

4.6 Select operating temperature

Set the operating temperature on tempera-

ture selector

4

. Set temperature selector

4

to

for minimum output. Refrigeration per-

formance can be increased, if required, by

turning temperature selector

4

towards

(maximum output). However, this will

increase energy consumption. To save

energy, output can be reduced again by

turning temperature selector

4

back towards

(minimum output).

4.7 Emptying the drip tray

Condensation water may collect in the drip

tray

12

. Depending on the duration and

intensity of operation, the drip tray

12

should be checked regularly and emptied if

necessary:

1. Pull the drip tray

12

forwards and out.

2. Empty out any condensation water

present.

RP71570 MiniCool LB4 Seite 5 Dienstag, 6. Dezember 2011 10:18 10

1 2 3 4 5 6 7 8 9 10 11 12 ... 61 62

Comments to this Manuals

No comments