Silvercrest SZP 40 A1 User Manual download pdf (Page 8)

6

GB

6. Operation

6.1 Assembling the citrus

press

DANGER!

Only plug the mains plug8 into the

wall socket after the device has

been completely assembled.

1. Pull the desired length of power cable8

out of the cable compartment7.

2. Place the motor block6 on a dry, solid

and level surface.

3. Place the juice container3 on the motor

block6.

4. Place the juicer cone with screen2 on

the drive axle5.

5. Insert the mains plug8 into a wall sock-

et corresponding to the technical data.

6.2 Extracting the juice from

citrus fruits

WARNING!

~ Ensure that no foreign body is on the

screen2 or in the device when operat-

ing it.

~ Do not put excessive pressure on the

juicer cone2.

NOTES:

• Empty the juice container3 at the latest

when juice fills the container up to just

under the screen2.

• In order to achieve the largest juice

yield possible, the juicer cone changes

the direction of rotation after several

starts and stops.

1. Place a container under the outflow4.

2. Figure A: open the outflow4 by press-

ing lightly on the top.

3. Cut the citrus fruits in half.

4.

Figure B:

exert slight pressure on the

halves of the citrus fruit when pushing

the cut surface down onto the juicer

cone

2

. The juicer cone

2

starts turning,

and the juice flows into the juice contain-

er

3

.

5. As soon as you stop pressing on the

juicer cone



2, the device stops.

6. Figure C: when you have finished ex-

tracting juice, or want to change the

container under the outflow4, close the

outflow4 by pressing lightly from be-

low.

7. Clean the device after each use as soon

as possible so the pulp does not start

drying to the surface.

7. Cleaning

Clean the device prior to its first use!

DANGER! Risk of electric

shock!

~ Pull out the mains plug8 from the wall

socket before cleaning the citrus press.

~ The motor block6, the power cable

and the mains plug8 must not be im-

mersed in water or any other liquids.

WARNING!

Do not use any astringent or abrasive clean-

ing agents.

NOTE: clean the device after each use as

soon as possible so the pulp does not start

drying to the surface.

1. Remove the lid

1

, if necessary.

2. Remove the juicer cone 2 and the juice

container3.

3. Figure D: open the juice container out-

flow4, carefully press the sides togeth-

er and fully fold down the outflow.

4. Figure D: take the outflow4 out of the

bottom of the juice container3, and put

it in the basket of the dishwasher.

__RP104443_B4.book Seite 6 Donnerstag, 20. November 2014 3:53 15

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 61 62

Comments to this Manuals

No comments