Silvercrest SZP 40 A1 User Manual download pdf (Page 7)

5

GB

~ Only connect the mains plug to a prop-

erly installed and easily accessible wall

socket whose voltage corresponds to

the specifications on the rating plate.

The wall socket must continue to be eas-

ily accessible after the device is

plugged in.

~ Ensure that the power cable cannot be

damaged by sharp edges or hot points.

~ The device is not fully disconnected from

the power supply, even after it is

switched off. In order to fully disconnect

it, pull out the mains plug.

~ When using the device, ensure that the

power cable cannot be trapped or

crushed.

~ To pull the mains plug out of the wall

socket, always pull on the mains plug,

and never on the power cable.

~ Disconnect the mains plug from the wall

socket…

… if there is a fault,

… if you are not using the citrus press,

… before you assemble or disassemble

the citrus press,

… before you clean the citrus press and

… during thunderstorms.

~ To avoid any risk, do not make modifi-

cations to the device.

WARNING! Risk of injury by

turning parts

~ Do not touch the rotating juicer cone di-

rectly. Do not touch rotating parts with

small spoons or similar utensils. Keep

long hair or loose clothing away from

rotating parts as well.

~ Only plug the mains plug into the wall

socket after the device has been com-

pletely assembled.

WARNING! Risk of material

damage

~ Do not block and overload the motor.

Do not put excessive pressure on the

juicer cone.

~ Ensure that no foreign body is on the

screen or in the device when operating

it.

~ In order to avoid damage to the device,

interrupt pressing immediately, if the

juicer cone is not turning or having diffi-

culty turning. Pull out the mains plug

and check if there is a foreign body in

the device.

~ The device is fitted with non-slip silicon

feet. Because furniture can be coated

with a wide variety of varnishes and

plastics, and treated with various care

products, the possibility cannot be ex-

cluded that some of these substances

have ingredients that may attack and

soften the silicon feet. If necessary,

place a non-slip mat under the device.

~ Place the device on a stable, flat sur-

face.

~ Never place the device on hot surfaces

(e.g. hot plates) or near heat sources or

open fire.

~ Do not use any astringent or abrasive

cleaning agents.

4. Items supplied

1Lid1

1 Juicer cone with screen2

1 Juice container3

1 Motor block6

1 Operating Instructions

5. How to use

• Remove all packing material.

• Check to ensure that all parts are pre-

sent and undamaged.

• Clean the device prior to its first

use (see “Cleaning” on page 6)!

__RP104443_B4.book Seite 5 Donnerstag, 20. November 2014 3:53 15

1 2 3 4 5 6 7 8 9 10 11 12 ... 61 62

Comments to this Manuals

No comments