Silvercrest SGT 10.6 A2 Service Manual download pdf (Page 97)

SilverCrest graphics tablet SGT 10.6 A2

English - 95

Replacing the battery

To replace the battery proceed as follows:

1. Remove the cap.

2. Push the cover upwards slightly and lift it

off.

Do not push the cover too far

upwards, as the tabs at the front could

otherwise break off.

3. Replace the used battery with a new

battery (1.5 V, type AAA ). The positive

pole (+) must always point towards the

open end of the pen.

Always ensure correct polarity of the

battery!

4. Place the tabs of the cover into the front of

the bottom section and carefully push

down until the cover snaps into place on

the bottom section. Do not use any force.

5. Replace the pen cap.

Remember to protect the environment. Used batteries should not be disposed of in domestic waste.

They must be taken to a collection point for old batteries.

Replacing the pen nib

To replace the pen nib proceed as follows:

1. Grip the nib (O) with the nib extractor (Q)

and pull the nib out of the pen.

2. Push a new nib (O) as far as possible into

the pen.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102

No comments

Silvercrest SGT 10.6 A2 Service Manual Page 97