Silvercrest SGT 10.6 A2 Service Manual download pdf (Page 77)

SilverCrest graphics tablet SGT 10.6 A2

English - 75

 Only use a battery of the same type and the same charging capacity. Always ensure correct

polarity of the battery. Remove the battery if you will not be using the device for a prolonged

period of time, as it can leak. Contact with the skin will cause chemical burns. For this reason it

is absolutely essential to remove leaking batteries with acid-resistant protective gloves.

 Never try to recharge batteries and never throw them into an open fire (risk of explosion).

 Remember to protect the environment. Used batteries should not be disposed of in domestic

waste. They must be taken to a collection point for old batteries.

Prior to use

The graphics tablet helps you to edit graphics and photos. You can also use the graphics tablet to

create drawings and write notes on your computer in the same way as you would using a sheet of

paper. Proceed as follows to start using your graphics tablet quickly and easily.

Step 1: Inserting the battery into the digital pen

To insert batteries proceed as follows:

1. Remove the cap.

2. Push the cover upwards slightly and lift it

off.

Do not push the cover too far

upwards, as the tabs at the front could

otherwise break off.

3. Remove the film from the supplied battery

and insert the battery. The positive pole (+)

must always point towards the open end of

the pen.

Always ensure correct polarity of the

battery!

4. Place the tabs of the cover into the front of

the bottom section and carefully push

down until the cover snaps into place on

the bottom section. Do not use any force.

5. Replace the pen cap.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 101 102

No comments

Silvercrest SGT 10.6 A2 Service Manual Page 77