Silvercrest SKD 1000 A1 Operations Instructions download pdf (Page 9)

SKD 2300 A1

7

Warning!

Ensure that there is

sufﬁcient distance from the wall,

ﬁxtures and other appliances. The

distance must be at least 1 m to

exclude the risk of ﬁre.

1. Select a location in compliance with the

safety information (see “4. Safety

information” on page 3).

2. Plug the mains plug into a wall socket

that complies with the technical data.

Note:

If you have plugged other power

consumers into the same circuit, check

that the maximum load for the installed

fuse is not exceeded, as otherwise the

fuse will trip.

5.3 Inserting the batteries

If the appliance is new or the batteries in the

remote control are ﬂat, new type AAA/R03

batteries must be inserted.

1. Push off the battery compartment cover

on the underside of the remote control.

2. Remove the old batteries if present.

Note:

Please observe the instructions for

disposal (see “9.2 Disposable/

rechargeable batteries” on page 10).

3. Insert new batteries.

Note:

Ensure the correct polarity (+/–).

The correct polarity is shown on the

bottom of the battery compartment.

4. Close the battery compartment again.

6. Operating

6.1 Using the appliance for the ﬁrst

time

1. Plug the mains plug into a wall socket

that complies with the technical data (see

“3. Technical data” on page 3).

2. Switch the mains switch

9

to

ON

to

switch on the power supply.

The lamp in the main switch

9

lights up

and you hear a beep.

3. Press the On/Off button

22

to switch the

appliance on.

The display

5

lights up.

The appliance is now ready for use and can

be operated by means of the remote control

or control panel

2

.

6.2 Selecting the temperature

Notes:

• Temperature display

20

:

– set speciﬁed temperature

• Temperature display

21

:

– measured actual temperature

• Temperature is measured directly at the

appliance using temperature sensor

8

. It

may be some time before the entire

room has also reached this temperature.

1. To choose whether you wish the

temperature to be displayed in °C or °F,

press button

24

.

Selected unit of measurement

14

is

shown in the display

5

.

2. Press the “Increase temperature” button

16

to increase the desired temperature up to a

maximum of 37 °C (99 °F).

Selected speciﬁed temperature

20

is

shown in display

5

.

RP74308 Konvektor LB3so Seite 7 Mittwoch, 16. Mai 2012 3:10 15

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 49 50

Comments to this Manuals

No comments