Silvercrest SIUR 10 A1 User Manual Page 133

  • Download
  • Add to my manuals
  • Print
  • Page
    / 154
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 132
130
SIUR 10 A1
GB
Insert the battery into the battery compartment. The side with the marking
"+" must be facing upwards.
Close the battery compartment by attaching the cover and then, using a
coin, turn it to the right as far as it will go.
Replacing the remote control battery
Before using the remote control for the fi rst time, you
will have to pull out the plastic strip protruding from
the battery compartment. This plastic strip insulates
the battery and prevents it discharging prematurely.
If the remote control is no longer functioning reli-
ably, you have to replace the battery. To do this,
press the lock tab in the direction of the arrow with
your fi ngernail, and pull the battery carrier out of
the remote control. Remove the discharged battery
and then place a fresh battery of the same type
(CR2025) in the carrier so that the "+" marking is
facing upwards. Slide the battery carrier back into
the remote control.
Setting up the device
Select a suitable location for the device (you should also refer to chapter
Requirements for the set up location).
Providing mains power
Insert the mains connecting cable plug into a mains socket. The time
display (0:00) is shown in the display
.
VHF cable antenna
Completely unwind the cable antenna for VHF radio reception.
Handling and use
This section provides you with important information on handling and using the
device.
Switching on and off
Once the device has been connected to the power supply it is already switched
on. You can switch between clock/standby and radio operating mode using the
key on the device or the key on the remote control.
IB_86209_SIUR10A1_LB1.indb 130IB_86209_SIUR10A1_LB1.indb 130 11.03.13 09:2111.03.13 09:21
Page view 132
1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 153 154

Comments to this Manuals

No comments