Silvercrest SFB 10.1 C3 Specifications download pdf (Page 101)

SilverCrest SFB 10.1 C3

English - 99

automatic search had been stopped with a slight delay and further

codes have been sent.

During the automatic search, the remote control responds to the

and buttons only.

5. After you have pressed the button to stop searching you can

press the buttons to send the previous or next codes

manually. If your device responds again to a code, you have found

a suitable code. Press to exit the automatic search. The codes

are saved and the display reads “SUCCESS”.

6. Or press to exit the automatic search. This will not save any

codes.

7. After the remote control has finished transmitting the last available

code from the code list, the search will stop and after a few seconds

the start window appears.

Press to go back one menu level. To return to the start window,

press one of the device buttons.

Direct code input (CODE SET)

1. Press and hold the button for 3 seconds.

2. Press , select “CODE SETUP” and then press .

3. Press , select “CODE SET” and press to confirm.

The selected device flashes and the currently set device code

appears on the display. At this point you can select a different device

by using the device buttons. Confirm your selection with .

4. The first digit of the 4-digit device code currently set flashes.

5. Enter the correct 4-digit code for the device selected by using the

number buttons. You can find the 4-digit code in the device code list

supplied.

6. Press to confirm the entry. The display reads “SUCCESS”

followed by “CODE SET”.

7. Invalid CODES cannot be found in the CODE list. If you enter an

invalid code “NOT FOUND” appears on the display and you can

then enter the correct code.

Press to go back one menu level. To return to the start window,

press one of the device buttons.

Flex mode

For the different device buttons there are preset code lists for specific

device groups. Normally, you will assign the corresponding device types

to the device buttons. For example, you will assign programming a VCR

to the device button, a DVD player to the device button,

etc. Furthermore, the Flex mode conveniently lets you assign a device

from any device group to the and buttons. The requisite is

that you assign the code list of the desired device group (where the

device belongs to) to the or button you want to use for

this device.

The code lists (e.g. 0 for TV or 2 for DVD) belonging to each device

group can be found in the table below:

TV VCR DVD DSAT BD AMP CBL CD

0 1 2 3 4 5 6 7

For direct code input:

1. Press and hold the button for 3 seconds.

2. Press , select “CODE SETUP” and press to

confirm.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 113 114

Comments to this Manuals

No comments

Silvercrest SFB 10.1 C3 Specifications Page 101

Comments to this Manuals