Silvercrest Electrical Sockets User Manual download pdf (Page 24)

24 GB

Setting up

Q

Setting up

Q

Preparing the remote

control (ﬁg. A)

1. Open the battery compartment on

the back of the remote control by

pushing away the battery compart-

ment cover

4

downwards. Insert

two batteries AAA. Make sure you

ﬁt the battery the right way round

(polarity).

2. Press one of the ON / OFF buttons

2

or

3

to test whether the remote

control works; if it does, the power

indicator light will come on

1

.

Q

Setting up the remote-

controlled socket

1. Insert the remote-controlled socket

into an earthed household socket

and switch it on with the ON / OFF

switch

5

. The LED operating status

display

6

will come on.

2. Point the remote control at the remote-

controlled socket at a distance of

approx. 50 cm.

3. Press the LEARN button

7

of the

remote-controlled socket for ap-

prox. 3 seconds and release it

again. The LED operating status dis-

play

6

will ﬂash for approx. 10

seconds. While it is ﬂashing, press the

desired ON button of the channel

ON / OFF button

2

(A, B, C or D)

of the remote control. The LED op-

erating status display

6

will now

shine permanently. You can now

switch a connected consumer on or

oﬀ using the remote control.

4. Repeat this procedure with the other

remote-controlled socket.

5. You can switch several remote-con-

trolled sockets on and oﬀ at the

same time using the ON / OFF but-

ton

2

of one channel. In addition,

you can programme six remote

controls one after the other and use

them for individual receivers. This

means you can switch one appliance

on and oﬀ from up to six diﬀerent

places.

6. In this case, synchronise every remote-

controlled socket with the channel

of the remote control.

7. The coding of the remote control

will be maintained even when you

change the batteries.

8. If

you disconnect the remote-controlled

socket from the power supply, the

codings will be permanently stored.

9. In order to delete the codings again,

press the LEARN button

7

longer

than 6 seconds until the LED oper-

ating status display

6

starts to ﬂash.

All codings will now be deleted.

10. Avoid interference: Make sure that

the distance between the various

remote-controlled sockets is ap-

prox. 50 cm.

11. Every remote-controlled socket also

has a manual ON / OFF switch

5

.

You can switch the remote-controlled

socket on and oﬀ without using the

remote control. The LED operating

status display

6

will indicate

whether the remote-controlled

socket is in the ON / OFF mode.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29

Comments to this Manuals

No comments