Silvercrest Electrical Sockets User Manual download pdf (Page 37)

41 GB

Setting up

ton

2

of one channel. In addition,

you can programme six remote

controls one after the other and use

them for individual receivers. This

means you can switch one appliance

on and oﬀ from up to six diﬀerent

places.

6. In this case, synchronise every remote-

controlled socket with the channel

of the remote control.

7. The coding of the remote control is

maintained when you change the

battery.

8. If you disconnect the remote-con-

trolled socket from the power supply,

the codings will be permanently

stored.

9. In order to delete the codings again,

press the LEARN button

7

longer

than 6 seconds until the LED oper-

ating status display

6

starts to ﬂash.

All codings will now be deleted.

10. Avoid interference: Make sure that

the distance between the various

remote-controlled sockets is ap-

prox. 50 cm.

11. Every remote-controlled socket also

has a manual ON / OFF switch

5

.

You can switch the remote-controlled

socket on and oﬀ without using the

remote control. The LED operating

status display

6

will indicate

whether the remote-controlled sock-

et is in the ON / OFF mode.

Q

Setting up the remote-

controlled dimmer socket

(FSD B 20-A) (ﬁg. B)

1. Insert the remote-controlled socket

into an earthed household socket

and switch it on with the ON / OFF

switch

5

.

2. Point the remote control at the remote-

controlled socket at a distance of

approx. 50 cm.

3. Press the LEARN button

7

of the

remote-controlled socket for ap-

prox. 3 seconds and release it again.

The LED operating status display

6

will ﬂash for approx. 10 seconds.

While it is ﬂashing, press the desired

ON button of the channel ON /

OFF button

2

(A, B, C or D) of the

remote control. The LED operating

status display

6

will now shine

permanently. You can now switch a

connected consumer on or oﬀ using

the remote control.

4. The coding of the remote control will

be maintained even when you

change the battery.

5. When you unplug the remote-con-

trolled sockets from the power supply,

the codings will be stored perma-

nently.

6. Avoid interference: Make sure that

the distance between the various

remote-controlled sockets is ap-

prox. 50 cm.

7. In order to delete the codings again,

press the LEARN button

7

longer

than 6 seconds until the LED oper-

ating status display

6

starts to ﬂash.

All codings will now be deleted.

66538_silv_Funkschaltset_Content_ES-IT-PT-GB-DE.indd 41 28.06.11 15:13

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 51 52

Comments to this Manuals

No comments