Silvercrest TLG 500 B1 User Manual download pdf (Page 45)

TLG 500 B1

Handling and operation

In this chapter you will receive important information for the handling and opera-

tion of the device.

Charging batteries

♦ Place the device on a smooth, level and slip resistant surface.

♦ Compare the technical details with those of your power supplier. If they

match, insert the plug into a mains power socket. The LEDs glow red and

green once. The battery charger is now ready for use.

♦ Insert the batteries into the loading slots . Press the 9 V Block batteries

into the loading slot until they audibly engage.

NOTICE

►

1 to 6 batteries can be individually charged:

- 4 x Type C or Type D in the loading slots

1 to 4

- 4 x Type AA or AAA in the loading slots 1 to 4 and additionally

2 x Type 9 Volt Block batteries in the loading slots

5 and 6.

♦ The charging process now begins. The battery charger has an LED for

each compartment in the loading slot

. The LEDs of the respective

loading slots

show the charge status of the individual batteries.

During the ﬁ rst 5 seconds the battery charger carries out a capacity test:

LED Colour

Capacity of the

battery

Green > 90 %

Green blinking 80 - 90 %

Red 70 - 80 %

Red blinking < 70 %

NOTICE

►

Should the LED of the loading slot

blink red for more than 5 seconds,

then the battery is either not properly inserted into the loading slot

it is defective.

♦ When the battery capacity has been determined, the charging process begins.

IB_93496_TLG500B1_LB5.indb 42IB_93496_TLG500B1_LB5.indb 42 19.09.13 14:4719.09.13 14:47

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 62 63

No comments

Silvercrest TLG 500 B1 User Manual Page 45