Silvercrest A1 User Manual download pdf (Page 7)

- 5 -

Charging

Note:

Check to ensure that the on/off switch 6 has been

slid back (to the position "0") before starting the

charging process.

• Place the hand vacuum cleaner from above into

the wall holder 3 so that the barrel plug 5 slips

into the socket on the hand vacuum cleaner.

The charge indicator lamp 7 glows red and the

charging process begins.

IMPORTANT:

• When the charging process is complete, which

may take 12 to 15 hours for completely dis-

charged batteries, the device switches over to a

trickle charge (maintenance function) automati-

cally. Nevertheless, in order to avoid possible

damage to the batteries, do not leave the appli-

ance permanently connected to the power

adapter 4.

• Reconnect the appliance with the power adap-

ter 4 when the suction power has become

noticeably weaker.

Note:

The hand vacuum cleaner can also be charged

directly via the power adapter 4. For this, remove

the barrel plug 5 with a slight twist from the wall

holder 3 and insert it into the socket on the hand

vacuum cleaner.

Operation

Warning:

The suction opening must always be open and

unblocked. Blockages lead to overheating and da-

mage to the motor.

Tips:

• Make certain that the dust filter 9 is always

inserted before using the appliance.

• As the maximum, suck up only as much liquid as

will fill the dirt container 0 to the MAX mark.

1. Take the hand vacuum cleaner from the wall hol-

der 3 or, if you do not use the wall holder 3,

remove the barrel plug 5 from the socket.

2. If required, place the appropriate nozzle into the

suction opening:

• the crevice nozzle 2, to clean narrow and

difficult to reach locations.

• the wet suction nozzle 1 to vacuum liquids up.

Note:

After you have vacuumed up liquids, immediately

clean the dirt container 0. Otherwise bacteria and

microbes could form in it! Ensure that the dust filter

9/der dust filter bag is completely dry before

using the appliance again.

3. To switch the appliance on, slide the on/off

switch 6 forwards.

4. When you have finished using it, slide the on/

off switch 6 to the rear.

Place the hand vacuum in the wall holder 3

and start the charging process when the vacuum

power has become noticeably weaker.

IB_58810_SAS72A1_LB6 28.10.2010 9:20 Uhr Seite 5

1 2 3 4 5 6 7 8 9

Comments to this Manuals

No comments

Silvercrest A1 User Manual Page 7

Comments to this Manuals