Silvercrest KH 2431 User Manual download pdf (Page 74)

Setting up and connecting

KH 2431

♦ Move the lever to the rear position to lower the pick-up arm.

♦ Align the tone arm by turning the counterweight

in such a way that it is

in equilibrium (see ﬁ gure) .

♦ Swing the tone arm back into its original position.

♦ Hold the counterweight ﬁ rmly and then turn the adjusting ring so that the

"0" marking is at the top.

♦ Rotate the counterweight to the left, to the position "2.5". This corresponds

to a tr

acking pressure of 2.5 grams.

NOTE

Should the tone arm jump, slide, or does not move forward, the tracking pres-

sur

e and anti-skating force are not set correctly.

► Raise or lower the tracking pressure by turning the counterweight on the tone

arm

to the left or right.

Setting the anti-skating force

Due to the friction of the rotating disc with the needle, the tone arm is pulled

inwards and the needle presses more heavily on the inner groove ﬂ ank of the

disc. The anti-skating setting balances this out. The anti-skating force should be

set to the same value as the tracking pressure.

♦ Turn the anti-skating knob

to the position "2.5".

Electrical connection

■ Before connecting the device compare the connection data (voltage and

frequency) with that on the rating plate of your electric supply.

This data must agree in order to avoid damaging the device.

■ Make sure that the power cable is not damaged and is not laying over

hot sur

faces and/or sharp edges.

■ Ensure that the power cable is not over taut or kinked.

■ Do not allow the cable to dangle over edges (trip wire eﬀ ect).

■ The mains power socket must be easily accessible so that the power cable

can be easily disconnected in an emer

gency.

Buch_53140_LB1.indb 71 05.04.12 12:10

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 93 94

No comments

Silvercrest KH 2431 User Manual Page 74