Silvercrest SDRB 1000 B1 User Manual download pdf (Page 9)

- 6 -

Should the mains water at your locality be rated as

hard, it is recommended that you mix mains water

with some distilled water. Otherwise, the jets for the

steam blast function could calcify (become blocked)

prematurely.

To extend the optimal steam blast function, mix mains

water with distilled water according to the table.

The water hardness level can be queried at your

local water works.

Attention!

Before refilling with water, ALWAYS remove the po-

wer plug 7 from the mains power socket! There is

a risk of electric shock!

• Lift the watertank 1 up vertically, in that you slide

the runlocking device 4 for the watertank 1 to the

rear until the watertank 1 allows itself to be lifted

off. Grasp the watertank 1 with your thumb and in-

dex finger on the hatched markings to lift it vertically

upwards. The temperature regulator 3 remains on

the appliance and is not lifted off.

• Open the water fill opening 2 to the watertank 1.

• Using the measuring beaker t, fill the water-

tank 1 with mains water to the "Max" marking,

but no further.

Water hardness

Ratios - distilled

water to mains

water

very soft / soft 0

medium 1: 1

hard 2: 1

very hard 3: 1

• Close the water fill opening 2 to the water tank 1.

Ensure that the lug on the water fill opening 2

sits in the indentation on the lid. Only in this way

is the watertank 1 properly closed.

• Replace the watertank 1 back onto the appliance.

The watertank 1 must audibly engage with the

unlocking device for the watertank 4.

Attaching/detaching the brush

attachment

Attention!

NEVER attempt to attach or detach the brush attach-

ment w when the appliance is heated up.

Risk of Burns!

• To use the steam and brush function, place the

brush attachment w onto the steam brush.

• To do this, slide the brush attachment w all the

way along the guide to the end. The unlocking

device of the brush attachment q must engage

audibly.

• To be able to use the ironing function, remove

the brush attachment w from the steam brush.

• To do this, press the unlocking device q down-

wards and, at the same time, pull the brush attach-

ment w away to the front.

Steam brush function

• Place the brush attachment w onto the applian-

ce. This must engage audibly with the unlocking

device on the brush attachment q.

• Insert the power plug 7 into a correctly installed

and earthed mains power socket.

• To generate steam, set the temperature regulator 3

to at least ••• or higher. The heating-up control

lamp 5 glows. As soon as the set temperature has

been reached, the heating-up control lamp 5

goes out.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 63 64

Comments to this Manuals

No comments

Silvercrest SDRB 1000 B1 User Manual Page 9

Comments to this Manuals

Related products and manuals for Irons Silvercrest SDRB 1000 B1