Silvercrest SDBK 2400 C2 User Manual download pdf (Page 13)

11

GB

9. Storage

DANGER!

Store the steam iron out of the reach

of children.

1. Set the temperature controller 20 to

MIN.

2. Place the iron on the stand 13 and set

the switch 12 to the middle position .

3. Allow the device to cool down.

4. Set the steam flow rate controller 3 to

.

5. Set the switch 12 to the upper position

.

6. Remove the iron from the stand 13 and

pour off any remaining water through

the filling opening of the water tank (un-

der the lid 2).

7. Place the iron on the stand 13 and set

the switch 12 to the middle position .

8. Figure E: coil up the power cable in

the base of the stand.

9. Store the iron and the stand 13 in an

upright position.

10. Disposal

The symbol showing a

wheelie bin crossed through

indicates that the product re-

quires separate refuse collec-

tion in the European Union.

This applies to the product

and all accessories marked

with this symbol. Products identified with this

symbol may not be discarded with normal

household waste, but must be taken to a col-

lection point for recycling electric and elec-

tronic appliances. Recycling helps to reduce

the consumption of raw materials and pro-

tect the environment.

Packaging

When disposing of the packaging, make

sure you comply with the environmental reg-

ulations applicable in your country.

11. Trouble-shooting

If your device fails to function as required,

please try this checklist first. Perhaps there is

only a minor problem, and you can solve it

yourself.

DANGER! Risk of electric

shock! Do not attempt to repair the

device yourself under any

circumstances.

Fault Possible causes/Action

No

function

• Connect the device to the

mains power supply.

• Use the temperature control-

ler 20 to turn up the temper-

ature.

Little or

no steam

• Fill the water tank 17 to at

least one quarter full.

• Switch on the steam flow

rate controller 3

().

• Run the self-cleaning cycle.

Steam

burst is

not work-

ing.

• Fill the water tank 17 to at

least one quarter full.

• Set the right temperature.

• Leave a pause of a few sec-

onds between steam bursts.

Spray

burst is

not work-

ing.

• Fill the water tank 17 to at

least one quarter full.

• For the first spray burst, you

need to pump several times.

__RP37102_Dampfbügeleisen_B3.book Seite 11 Montag, 2. September 2013 8:00 20

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 97 98

Comments to this Manuals

No comments