Silvercrest SUL 1000 A1 Service Manual download pdf (Page 72)

72 GB/MT

Before first use

The device is ﬁtted with 2 NiMH rechargeable batteries and an

overcharge protection system so that the batteries can be topped up

without being overcharged.

j Connect the cable of the plug-in mains adapter to the charging

station

of the hair and beard clippers.

j Avoid injury and damage to the device! Make sure that

the device is switched oﬀ before you charge the rechargeable

batteries.

j Insert the plug-in mains adapter (wide voltage range 100 - 240 V)

into a mains outlet socket that meets the requirements of the device.

j The charge state indicator

on the front of the device illuminates

red and shows the battery symbol (the symbol indicating that the

device is connected to the mains) and the value indicating the %

of the full charge achieved. After a charge state of approx. 20 %

has been achieved, the charge state indicator

changes colour to

blue and the relevant % value for the charge capacity ﬂashes until

that charge state is achieved. The rechargeable batteries are fully

charged when the 100 % mark stops ﬂashing and is continuously

illuminated.

j The charge state indicator

switches oﬀ a few seconds after

completion of the charging process.

j The device can operate with fully charged batteries for up to

about 60 minutes when disconnected from the mains.

Operation with the plug-in mains adapter:

If your hair and beard clippers stop during use because of discharged

or weak rechargeable batteries, you can continue by connecting the

plug-in mains adapter.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 100 101

No comments

Silvercrest SUL 1000 A1 Service Manual Page 72