Silvercrest SAB 160 A1 User Manual download pdf (Page 174)

170

Installation

SAB 160 A1

To connect the device to two speakers use only the cables for the front speakers.

NOTICE

►

Make sure that a permanent positive connection is applied to the station

memory of connection 4 in the ISO block A.

► In some automobile models the standard conﬁ guration of the connections

[4] and [7] in ISO block A are interchanged at the factory. If this is the

case the station memory can be lost. To correct this, the connections 7

(Ignition positive) and 4 (Permanent positive) in the ISO Block A must be

swapped. For this, insert the supplied adapter cable

between the ISO-

Block A

of the radio and the vehicle wiring harness. On the adapter

cable

, connect the red wire of the ISO connector with the yellow wire of

the ISO socket and the yellow wire of the ISO connector with the red wire

of the ISO socket (see also the rear fold-out side).

► You can connect an external ampliﬁ er to the audio cinch output. For this

follow the operating instructions for the external ampliﬁ er.

IMPORTANT

►

When using the adapter cable for the ISO-Block A

, both connections

(red and yellow wires) must be connected with each other. If they are not,

there is the risk of a short circuit!

Antenna power connection

IMPORTANT

Possible damage to the device!

► Never burden the connector for the antenna current with the motor power

cable of the antenna or with other consumers.

The connection for the antenna power is available for a relay controlled antenna.

The relay then automatically extends the antenna when the device is switched

on. When switched oﬀ the antenna retracts. This connection can also be used to

control an external ampliﬁ er. For exact connection information please consult the

ampliﬁ er’s operating instructions.

Connection of an external ampliﬁ er

For the connection of an external ampliﬁ er use the audio cinch output LINE OUT

For this follow the operating instructions for the external ampliﬁ er.

Connection of an external subwoofer

For the connection of an external subwoofer use the yellow cinch connector

SUBWOOFER

. For this follow the operating instructions for the external

subwoofer.

Buch_75726_LB1.indb 170 27.06.12 11:19

1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 203 204

Comments to this Manuals

No comments

Silvercrest SAB 160 A1 User Manual Page 174

Comments to this Manuals

Related products and manuals for Car radio Silvercrest SAB 160 A1