Silvercrest CRB-631 User Manual download pdf (Page 13)

Installation - CRB-631

lish

Speakers

Connect the speakers in accordance with the following diagram; incorrect connection

can cause damage to your radio or speakers.

Front left

Front right

Rear left

Rear right

Correct connection Incorrect connection

Caution!!

 Only use speakers which are not connected to ground.

 Only use speakers with a minimum rating of 30 W; weaker speakers could be

damaged at a high volume.

 Only use speakers with an impedance of 4 ~ 8 Ω (ohm). Speakers with a higher or

lower impedance could cause damage to your car radio.

 Do not use speakers with a 3-wire connection and never connect the negative

pole of the speaker to the vehicle ground (GND). The car radio CRB-631 is

equipped with a BTL circuit (bridging circuit) and each speaker must therefore be

connected with insulated wires as shown in the wiring diagram.

 The speaker cables and/or an optional external power amplifier must always be at

least 30 cm away from the antenna and/or all antenna extensions.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

No comments

Silvercrest CRB-631 User Manual Page 13